| Age | Commit message (Collapse) | Author |
|---|
|
This is to keep the top-level directory clean, to make it clear what is
core and what is a port, and to allow the repository to grow with new ports
in a sustainable way.
|
|
There are 2 changes:
- remove early initialisation of LSE and replaced it by LSEDRIVE config
(there is no reason to call HAL_RCC_OscConfig twice).
- add initialisation of the variables PLLSAI1Source and PLLSAI1M as they
are needed in Cube HAL 1.8.1.
|
|
This upgrades the HAL to the versions:
- F4 V1.16.0
- F7 V1.7.0
- L4 V1.8.1
The main changes were in the SD card driver. The vendor changed the SD
read/write functions to accept block number intead of byte address, so
there is no longer any need for a custom patch for this in stm32lib.
The CardType values also changed, so pyb.SDCard().info() will return
different values for the 3rd element of the tuple, but this function was
never documented.
|
|
There were several different spellings of MicroPython present in comments,
when there should be only one.
|
|
|
|
|
|
|
|
If RTC is already running at boot then it's left alone. Otherwise, RTC is
started at boot but startup function returns straight away. RTC startup
is then finished the first time it is used. Fallback to LSI if LSE fails
to start in a certain time.
Also included:
MICROPY_HW_CLK_LAST_FREQ
hold pyb.freq() parameters in RTC backup reg
MICROPY_HW_RTC_USE_US
option to present datetime sub-seconds in microseconds
MICROPY_HW_RTC_USE_CALOUT
option to enable RTC calibration output
CLK_LAST_FREQ and RTC_USE_CALOUT are enabled for PYBv1.0.
|
|
|
|
|
|
The DFU bootloader on the ST32F7 chip changes the clocksource
for various possible boot sources (UART1, UART3, I2C1-3).
This commit resets those clock sources back to their cold
reset values.
|
|
|
|
|
