openmano-mpy - MicroPython source and hardware configuration for OpenMano

Age	Commit message (Collapse)	Author
2014-03-22	stmhal: Add input() and pyb.input() functions.	Damien George

2014-03-22	stmhal: Add servo driver.	Damien George

2014-03-22	stmhal: Add time module with sleep function.	Damien George

2014-03-22	stmhal: Add os module with a few basic functions.	Damien George

2014-03-22	stmhal: Add PYBv10 config; add RNG support.	Damien George

2014-03-22	stmhal: USB CDC and MSC device work together.	Damien George

2014-03-21	stmhal: Add support for USB MSC device.	Damien George
	This gives a functioning, independent MSC device.
2014-03-20	stmhal: Add accelerometer driver; fix bug with LFN.	Damien George

2014-03-19	stmhal: Add lcd.c to Makefile, and init LCD in main.	Damien George

2014-03-17	stmhal: Add fatfs support, working with flash and SD card.	Damien George

2014-03-17	stmhal: Add flash write support and flash storage driver.	Damien George

2014-03-17	stmhal: Add SD card support.	Damien George
	Just low-level read/write support. No filesystem yet.
2014-03-15	stmhal: Get RTC working.	Damien George

2014-03-15	stmhal: Get USB CDC REPL working.	Damien George
	New USB HAL is quite a bit improved over previous one. Now has better callbacks and flow control. REPL over USB CDC now works as before, except for soft-reset (since USB driver uses malloc...).
2014-03-14	stmhal - add pin mapping, gpio, exti, usrsw	Dave Hylands

2014-03-14	stmhal: Get USB enumerating a CDC device.	Damien George
	Enumerates CDC device over USB, but doesn't transmit/receive yet.
2014-03-13	Cleanup systick for stmhal	Dave Hylands

2014-03-12	REPl working on UART6 with STMHAL	Dave Hylands

2014-03-12	stmhal: Get SysTick and HSE working.	Damien George

2014-03-11	Initial checkin with STM HAL	Dave Hylands
	This compiles and links, but hasn't been tested on a board yet and even if it was run, it doesn't currently do anything.